Resin Molds

Optimized Dimensions: In the classic curved design, we continuously optimize the size of the resin ring mold to be 5.5mm width- 2mm thickness, compared to other products’ 6mm width- 6mm thickness, making your fingers look slimmer。 14 Sizes Options: To ensure the right size, the resin molds are available in 14 sizes for you to choose from. You can choose your size according to the recommended size chart Size Marking: We mark the size on each resin ring silicone to make it easier for you to choose the right ring.Including ring number and inner arc diameter Special Notes: In order to make the ring a little thinner, the aperture into which the resin is dropped is also smaller, so the pipette(A 0.1ml pipette is recommended)should be tilted, deep into the aperture, and drip slowly to avoid wasting time. Dear, through the analysis and research on the feedback results of hundreds of products and thousands of customers, we finally determined a brand new silicone ring mold About the ring: 1. 14 different sizes to meet the needs of fingers of different thicknesses,(4-17 / diameter 14.9-25.3MM) 2. The resin ring mold size is 5.5mm wide and 2mm thick, making your fingers look slimmer and more delicate 3. There is a size note on each ring mold to let you choose the right size，including ring number and inner arc diameter Application scenarios: 1. Can be used as a ring gift for mother, wife, child 2. Can be used as a wedding gift for wife 3. Our resin mold can be made into ring or pendant necklace Prepare materials: Silicone pad AB resin or UV resin stirring rod Measuring cup or mini scale small tweezers dried flowers glitter dropper other decorations you like Ring making process: 1) Resin preparation: If it is UV resin (setting can be completed in tens of seconds or one or two minutes), it can be used directly. If it is AB resin (longer curing time), most resins are in a ratio of 1:1, pour into a measuring cup, stir clockwise, do not stir back and forth, it may be cloudy at first, and gradually become clear, and then if you find any Bubble, it doesn’t matter, put the resin for a while, the bubbles will disappear (for the use of resin, please refer to the instruction manual of the product purchaser) 2) Add dried flowers or glitter powder or other decorations you want to the prepared resin, stir well, because the dried flowers are relatively large, you can also add them in later steps 3) Slowly drop the prepared resin into the mold with a dropper (make sure the mold is clean and the mold is flat) 4) Be careful: the dripping resin should not be higher than the edge of the outer diameter of the ring 5) In order to guarantee better effect, it is recommended to let it sit for 24 hours, depending on the resin you use 6) After 24 hours, you can pick up dried flowers or other decorations with tweezers, and drop the resin at the same time, this step is optional 7) Leave it for 24 hours, the effect is better, it depends on the resin you use 8) Perfect rings and pendants are ready Some additions about epoxy resin: 1. Epoxy resin glue: In some places, it is called crystal glue, which is AB glue. It is a two-component AB glue. The main components are epoxy resin, benzyl alcohol and polyether ammonia, which have the characteristics of low viscosity, high transparency, yellowing resistance, good bending resistance and good toughness; the crystal glue is liquid before curing, clear and transparent, and completely odorless after curing. 2. The quality of UV glue is better, but the price is also relatively high 💚 Kindly note 💚: If you would like to order more quantity than shown is available, you are welcome to place one order fox maximum available quantity and place one more order again because we always have more, than shows in available items. Regards